Portable Elisa Microplate Reader With Large LCD Display For Read OD
Value,Accurate, fast aging
Microplate reader
General
Before you start installing and working with the reader, you should
read the safety precautions and regulations shown in this chapter.
Operator Qualification
Please note that the operation with Microplate Reader should be
carried out only by the doctor or clinical inspector who has
undergone necessary training provided by the sales agent.
Service Technician Qualification
To install, maintain and repair the instrument, a service
technician has to be trained on the instrument by the manufacturer
or their representative. A service technician is also expected to
be familiar with the normal operation of the instrument as
described in the User’s manual and the special operations as
described in the service manual.
Electrical
To use analyser safely, pay attention to the following items:
To prevent the risk of electrical shock and/or damage to the
instrument, Operator should not open the cover of the instrument.
Only authorized personnel, for example, service technicians, may
open the instrument to perform maintenance or repair.
Touching the main board when the power is on may cause severe
injury or death. Any problem, please ask for helps from your
supplier.
Mechanical
There is no risk presented by the mechanical parts of the
instrument when the instrument is closed. If the covers of the
instruments are removed, mechanical parts could cause personal
injury or the instrument may be damaged if the following advice is
not being considered: DO NOT wear loose garments or jewellery that
could catch in mechanisms. DO NOT put your fingers/hands into the
pathway or any part while the instrument is in operation. DO NOT
attempt mechanical repair unless the instrument is not in operation
or OFF.
Lamp
The source lamp becomes extremely hot during operation; never touch
the lamp when it is on! If the lamp needs to be changed, always
switch off the lamp by switching off the instrument and then wait
until the lamp has cooled down.
| Weight: | 8.1kg |
| Overall dimensions: | 430mm(L)×335mm(W)×175mm(H) |
| Power: | a.c.110V~220V,50-60Hz |
| Fuses: | T2AL250V |
| Work Environment: | temperature 10℃-30℃；Humidity ≤70% |
| Store Environment: | -20℃-55℃；Humidity ≤93% |
| Standard Wavelength: | 405,450,492,630nm,Ten optical fibers can be configured within 400
to 800 at a time; |
| Instrument sensitivity: | no less than 0.01L/mg. |
